| Module | 42 | Export Document: M42-checklist.doc | |||||||
| Base | 42 | Visual Inspection M42_visual_inspection.pdf | |||||||
| Paddle | A120 | ||||||||
| Hybrid | 93 | R-glued | |||||||
| Pitch Adaptors | Chips | Sensor | V_dep Volts | Last IV | HT cable | LT cable | |||
|---|---|---|---|---|---|---|---|---|---|
| R-side | PAs | Chips | 2440-14E | 30 | IV | HT-64 | LT-64 | ||
| P-side | PAs | Chips | 2439-05B | 30 | IV | HT-65 | LT-65 |
| Bare Chip | Front End Bond | Sensor End Bond | Burn-in | Bad Strips | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Noise Results Plots (eps/png) R-side P-side |
Noise Results Plots (eps/png) R-side P-side |
Noise Results Plots (eps/png) R-side P-side |
| Verified Lists |
| Action: | Comment: | |
| Manufacture | Foot Inspection -0.002mm | |
| MET1 | Before grinding | Pedestal Metrology |
| Comment | Matched to Hybrid 93 | |
| Comment | Hyb 93 is 890/2=445, 445+220 wire dia.= 665 target | |
| Comment | Target 665 - 492 Met1 = 173, Plus 2 extra= 175 to gring off | |
| MET2 | After grinding | Pedestal Metrology |